TPMS Reset Procedure
Make:Lincoln Model:Navigator Sub-Model:Ultimate Year:2006
FRD-2

Required Tools

 

For OE and most aftermarket sensors -

Sensor activation magnet


For OTI-002 sensors -

Activation Tool (AKA trigger tool) such as  Ateq VT55 or VT30


Preparation

 

1.   Review all data in your owner’s manual pertaining to your TPMS system.

2.   Verify that your vehicle is listed in the application coverage listing of the trigger tool. 

3.   Perform trigger tool software update.

4.   Verify that the OEM trigger tool is working (check battery if needed).  

Installation

Note: This step should be performed only by a tire technician who has been properly trained in the operation and installation of TPMS systems.

1.   Install Sensors - Properly install tire pressure sensors. 

2.   Tire Pressure - Confirm all tires are inflated to the pressure indicated on tire placard. (the tire placard is located on the door jam of your vehicle)


 

This is a sample tire pressure placard.

Not for this specific vehicle.

 

 

3.   Eliminate Interference - To ensure the control unit memorizes the correct sensor ID, the vehicle with the new sensor must be at least 3 m. (10 ft.) from any other TPMS pressure sensor not installed on that vehicle.

Relearn

Note: To enter the reset mode, Steps 1–6 MUST be completed within 60 seconds.

1.   Place the ignition in the off position and keep the key in the ignition.

 

2.   Press and release the brake pedal.

 


3.   Cycle the ignition from off to on three (3) times ending in the on position— DO NOT start the engine.

 

Press and hold the brake pedal for two (2) seconds, then release.

4.   Turn the ignition to off—DO NOT remove the key.

 

5.   Cycle the ignition from off to on three (3) times ending in on—DO NOT start the engine.

 

Note: If the reset mode has been entered successfully, the horn will sound once. The TPMS indicator will flash and, if equipped, the message center will display [TRAIN LF TIRE]. A double horn chirp indicates the need to repeat the procedure.

6.       Place TPM Activation Magnet on the valve stem of the left front tire pressure sensor. The horn will sound briefly to indicate that the tire pressure sensor has been recognized by the TPMS module.  

OR if the sensor is OTI-002

Place the Activation Tool on the left front tire wall at the valve stem and press the test button on the Activation Tool. The horn will sound briefly to indicate that the tire pressure sensor has been recognized by the TPMS module.  

Note: Do not wait more than two (2) minutes between resetting each tire sensor or the system will timeout and the entire procedure will have to be repeated on all four wheels.

7.   Place the TPM Activation Magnet on the valve stem of the right front tire pressure sensor. Repeat procedure for right rear and then for left rear tires.

OR if the sensor is OTI-002

Place the Activation Tool on the right front tire wall at the valve stem and press the test button on the Activation Tool.  Repeat procedure for right rear and then for left rear tires.

8.   When the tire training procedure is complete, the horn will sound once and the message center (if equipped) will display “TIRE TRAINING COMPLETE”.

Note: If the VSM does not recognize any one of the 4 tire pressure sensors during the tire training procedure, the horn will sound twice and the message center (if equipped) will display “TIRE NOT TRAINED REPEAT”. If this occurs, training procedure must be repeated from the beginning.

 

© Revolution Supply Co. Inc. 2012