TPMS Reset Procedure
Make:Toyota Model:Yaris Sub-Model:Base Year:2007, 2008, 2009, 2010, 2011

Before performing the re-learn procedure below, please review all data in your owner’s manual pertaining to your TPMS system.
 
Note if installing Oro-Tek sensors and using a factory scan tool use the last 7 numbers of the sensor ESN.

 

A properly formatted scan tool is required to learn new sensor ID’s when replacing sensors.

 

1.     Properly install tire pressure sensors.

 

This step should be performed only by a tire technician who has been properly trained in the operation and installation of TPMS systems.

 

2.     Confirm all tires are inflated to the pressure indicated on tire placard. (located in the door jam of your vehicle)

This is a sample tire pressure placard.

Not for this specific vehicle.

 

3.     Turn the engine switch to the ON position.

 

 

4.      Following the instructions supplied by the manufacturer of your properly formatted scan tool. Read the sensor ID's into your scan tool starting with the left front tire, contact tire sidewall near air valve and press the switch to learn the sensor id. Repeat on the three remaining tires in the following order:

 

                                                Right Front

Right Rear

Left Rear   

                                                                      

5.     Read the ID’s into ECU through the cars OBD port located under your cars dash by following the instructions of your properly formatted scan tool.

 

 

6.     Turn the ignition to the ACC or LOCK position to complete the process.


 

© Revolution Supply Co. Inc. 2012