TPMS Reset Procedure
Make:Hyundai Model:Genesis Coupe Sub-Model:2.0T Track Year:2010

Required Tools

Activation Tool (AKA trigger tool) such as Ateq VT55 or VT30

 


 

 

Preparation

1.   Review all data in your owner’s manual pertaining to your TPMS system.

2.   Verify that your vehicle is listed in the application coverage listing of the trigger tool. 

3.   Perform trigger tool software update.

4.   Verify that the OEM trigger tool is working (check battery if needed). 

Installation

Note: This step should be performed only by a tire technician who has been properly trained in the operation and installation of TPMS systems.

1.   Install Sensors - Properly install tire pressure sensors. 

2.   Tire Pressure - Confirm all tires are inflated to the pressure indicated on tire placard. (the tire placard is located on the door jam of your vehicle)

 

This is a sample tire pressure placard.

Not for this specific vehicle.

3.   Eliminate Interference - To ensure the control unit memorizes the correct sensor ID, the vehicle with the new sensor must be at least 3 m. (10 ft.) from any other TPMS pressure sensor not installed on that vehicle.

Relearn

Note:

1.   Following the instructions supplied by the manufacturer of your properly formatted scan tool. Read the sensor ID's into your scan tool starting with the left front tire, contact tire sidewall near air valve and press the switch to learn the sensor id.

 

2.   Place the activation tool on the wall of the LEFT FRONT tire at the valve stem and press the test button on the activation tool. 


3.   Place the activation tool on the wall of the RIGHT FRONT tire at the valve stem and press the test button on the activation tool. 


4.   Place the activation tool on the wall of the RIGHT REAR tire at the valve stem and press the test button on the activation tool. 


5.   Place the activation tool on the wall of the LEFT REAR tire at the valve stem and press the test button on the activation tool. 

Note: If there the spare tire has a TPMS sensor installed then place the activation tool on the wall of the SPARE tire at the valve stem and press the test button on the activation tool. 

6.   Plug the OBD adapter into the OBD plug under your dash. Turn ignition to ON position (engine off). Following the instructions supplied by the manufacturer of your properly formatted scan tool. Read the sensor ID’s into the electronic control unit (ECU) of your vehicle.


 

© Revolution Supply Co. Inc. 2012