TPMS Reset Procedure
Make:Ram Model:2500 Sub-Model:SLT Year:2011, 2012, 2013

ORO-TEK_Logo.jpg

 

Required Tools
None

Preparation
Review all data in your Owner’s Manual pertaining to the TPMS System

Installation

NOTE: This step should be performed only by a tire technician who has been properly trained in the operation and installation of TPMS Systems.
  1. Install Sensors – Properly install tire pressure sensors.

  2. Tire Pressure – Confirm all tire are inflated to the pressure indicated on tire placard.  (Placard is located on the driver’s side door jamb of vehicle)

    http://www.revolutionsupply.com/Relearn/Tire-Placard.jpg

    This is a sample Tire Pressure Placard.  Not for this specific vehicle.

  3. Eliminate Interference – To ensure the control unit memorizes the correct sensor ID, the vehicle with a new sensor must be at least 3m (10 ft.) from any other TPMS pressure sensor not installed on that vehicle.

Relearn

Vehicles TPMS System will Re-Learn the Sensor ID’s when the vehicle is driven above 30 mph for approximately 15 minutes.


DISCLAIMER:
All information is to be used as a reference only. Vehicle information is compiled from available manufacturer sources but accuracy is not guaranteed. The application information presented in this document is accurate to the best of our knowledge and is regularly updated with the latest data available in the marketplace. Due to the vast number of car models and spare parts from numerous vehicle manufacturers the exact application of parts is not always feasible. Always reference our website for the most up to date data. Damage claims on the basis of data in this catalog will not be considered.

©  Revolution Supply Co. Inc. 2013