TPMS Reset Procedure
Make:Mitsubishi Model:Mirage Sub-Model:DE Year:2014, 2015
Before performing the re-learn procedure below, please review all data in your owner’s manual pertaining to your TPMS system.


As of 4/1/2013, There is NO equipment in the industry with the protocol to communicate learned TPMS Sensor ID's into the vehicles ECU.  On some models, It has been noted that you can work around this issue by using a hand scanner to record you sensor id's and a Diagnostic Tool like the Snap-on Verus to hard code the sensor id's directly into the ECU.
1.     Properly install tire pressure sensors.


This step should be performed only by a tire technician who has been properly trained in the operation and installation of TPMS systems.

2.     Confirm all tires are inflated to the pressure indicated on tire placard. (located in the door jam of your vehicle)

This is a sample tire pressure placard.

Not for this specific vehicle.

3.     Following the instructions supplied by the manufacturer of your properly formatted scan tool. Read the sensor ID's into your scan tool starting with the left front tire, contact tire sidewall near air valve and press the switch to learn the sensor id.



4.     Repeat step 4 on the remaining tires, in the following order,

    Right front

Right rear

Left rear

5.     Connect Diagnostic Tool into the OBD plug under your dash. Turn ignition to ON position (engine off).  Following the instructions supplied by the manufacturer of the on-board diagnostic equipment, go to the TPMS Screen and enter codes and positons.  (Procedures vary by manufacturer of diagnostic tools)
NOTE: Some Models are not available on the above mentioned diagnostic unit to perform this procedure.

6.     Turn the ignition to the “OFF” position and unplug the diagnostic tool.


7.     Check the instrument cluster to insure that the TPMS warning light is off.



Example of TPMS warning light


© Revolution Supply Co. Inc. 2010